®
INSTALLATION INSTRUCTIONS
READ & SAVE THESE INSTRUCTIONS!
Automatic Heat Sensor
MODEL: AHS-200
For use with NuTone Attic Ventilators
The NuTone Model AHS-200 is a 200°F heat
sensor and is intended to be installed in the attic
and connected into the power line of a NuTone
Attic Ventilator. In the event the attic
MODEL AHS-200
temperature surrounding the heat sensor
reaches 200°F (for any reason, including fire),
THERMOSTAT
the unit will interrupt power to the ventilator
and then will be turned off.
TO 120vAC,
60 Hz
1. Located the heat sensor near the Attic
Ventilator thermostat so that it is up-roof
from the ventilator and thermostat.
2. Mount the heat sensor on the side of a roof
rafter so that it's pointing down toward the
living area of the home.
AHS-200 BOX
THERMOSTAT BOX
HEAT
SENSOR
WIRE
CONNECTOR
VENTILATOR
MOTOR
GREEN GROUND
SCREW
THERMOSTAT
WIRE
CONNECTOR
WIRE
CONNECTORS
ATTIC
LIVING AREA
ON/OFF SWITCH
120vAC, 60 Hz POWER,
PLUG GROUND
|
Milwaukee Impact Driver 9058 1 User Manual
MTD Tiller 217 310 000 User Manual
NAD Car Video System L 70 User Manual
NEC Telephone 2014 User Manual
NuTone Universal Remote ICA 441WH User Manual
Oki Printer 1220n User Manual
Olympus Camcorder D 340L User Manual
Panasonic Flat Panel Television CT 32SL32 User Manual
Panasonic Indoor Furnishings EP3513 User Manual
Panasonic Network Card MAZSxxx Series User Manual